UNOCODE PRO Operating manual - English
56 Copyright Silca 2017
Press ENTER to continue, the display shows:
Read the instructions on the display and fit the Z20 template into the
cutter side of the clamp, with Stop 0 as the reference.
Fig. 32
Lower the gauge and press ENTER to continue.
The display shows:
Read the instructions on the display, move the carriages manually so
that the Z20 template is taken into contact with the Z1 template (fig.
33) in the vertical zone after the stop, up against the front and up
against the stem.
Fig. 33
When the given position is reached, lower the safety shield and
press START.
First the display will show: “Positioning” (**)
And then:
To Next Page
Loading...
