Silca Unocode PRO - Page 27

Operating manual - English UNOCODE PRO
Copyright Silca 2017 23
Press ENTER to view the “new” key with the adjustments
made.The display will show:
- a black outline of the original key (key read).
- a blue outline of the key to be cut, with the adjustments made.
Fit the key blank into the clamp on the cutter side and secure.
Lower the safety shield and press START to proceed with
cutting.
Warning! The presence of this symbol indicates that adjustments to the card have been
applied!
First the display will show:
and then:
• Press STOP to confirm the end of the operation.
• Press ENTER if you wish to cut other keys.