Operating manual - English UNOCODE PRO
Copyright Silca 2017 25
• CODEMAKER cutting cards:
Note: on the UTP version the Search for cutting cards created
with Codemaker (optional program) is run only through the Silca
Key Program.
Customized cards created using CODE MAKER on the machine.
• Press F3 to view a list of CodeMaker cards.
EXAMPLE: Copy from SILCA cutting Card
1) Digit the card number (e.g.: 50):
Press ENTER, the display shows:
. . . . . . .
The dots shown represent possible cuts. The same card can be used
for a number of keys with a different number of cuts.
If a key is used with fewer cuts than the dots on the display, just digit a
partial combination.
2) Digit the cuts.
• Single side Side 1
• Double symmetric Side 1x2
• Double asymmetric Side 1 / Side 2
To Next Page
Loading...
