Silca Unocode PRO - Page 32

UNOCODE PRO Operating manual - English
28 Copyright Silca 2017
• Decoding by data card
Press F1 to decode the selected data card.
Figura 22
• Press ENTER to continue.
1) Press START to begin the DECODING operation.
Note: the decoding operation is not available for all data cards.
At the end of the reading operation the display shows:
Figura 23
• Press ENTER, the key will be cut with the original measurement of the card.
F1: In the event of decoding keys with asymmetrical cuts, press F1 to view the values for the 2nd side.
Decoding value HIGHER than the original depth value:
- GREEN arrow = ACCEPTABLE VALUE
- RED arrow = UNACCEPTABLE VALUE
Decoding value LOWER than the original depth value:
- GREEN arrow = ACCEPTABLE VALUE
- RED arrow = UNACCEPTABLE VALUE
Decoding
F1
Change side
Differences found
Depths read
Depth values
read
Original depth values
on card
F1