UNOCODE PRO Operating manual - English
30 Copyright Silca 2017
Note: the editing can be saved as User Parameters.
User Parameters
This function is used to vary working speed and the number of passes.
Fig. 24
Editing number of passes per key cut
Enter the field to edit the number of passes per key cut (max. 3). Default = 1.
Note: the editing can be saved as User Parameters.
Editing working speed
To edit carriage movement speed, set a lower or higher percentage using the F1 and F2 keys.
Note: the maximum variation allowed refers to the value set in the OPTIONS menu (pages 2/4), item “Speed
variation limits.
F1: to increase the percentage value
F2: to decrease the percentage value
F3: to reset the Silca default values for carriage speed
Note: the editing can be saved as User Parameters.
F4
Carriage movement speed
To Next Page
Loading...
