Operating manual - English UNOCODE PRO
Copyright Silca 2017 33
• Copy SILCA Data Card onto CODEMAKER
Note: the “Copy Silca cutting card in Codemaker” function on the UTP version is not enabled.
Press F2 to copy a SILCA data card on the CODEMAKER
and change some of the parameters.
ATTENTION: not all SILCA data cards can be copied onto
CODEMAKER. If there is no icon the data card involved
cannot be copied (due to incompatible data).
Press ENTER, the display will show:
The function “Copy SILCA data card” onto CODEMAKER can
be activated also by the CODEMAKER function.
To Next Page
Loading...
