Operating manual - English UNOCODE PRO
Copyright Silca 2017 35
• Changing the Types of Cut
All the data cards provided by Silca have the type of cut pre-set according to the original parameters.
The types of cut possible with UNOCODE PRO are: Normal, Flat, Laser and Vertical.
EXAMPLE OF HOW TO CHANGE THE TYPE OF CUT
:
- Press F1 key.
All the technical data regarding the types of cuts stored in the machine’s memory can be changed according to the user’s
requirements.
ATTENTION: for certain cutting methods the standard cutter U01W must be replaced with a specific cutter.
N
ORMAL
For conventional car and door keys.
F
LAT
Mainly used for car keys where the cut edges are rounded to
facilitate the movement of the blades when the key is put into the
lock.
L
ASER
Conjunction of the cutting angles is determined automatically by
the machine, allowing cuts to be made with variable angles; this
facilitates the smooth entry of the key into the lock, prolonging
the working life of the key.
V
ERTICAL
Necessary for special keys with small bits (Silca art. FO19P,
FO21P...) where a special cutter is required.
When this cutting method is used a special angled cutter is
needed.
Current cut type
Cut type set by Silca
as original
Feasible and selectable
options for the
selected card
To Next Page
Loading...
