–
User manual
•
Video Compression
–
This section allows you to configure video compression
parameters for any of the three available codec instances (Primary H.264, Secondary
H.264 and MJPEG). Most VMS software solutions will interact with these parameters
and thus it is suggested to leave these at default values in the web interface.
o
VBR aggressiveness is specific to this encoder and proposes various
levels (disabled to aggressive) of motion triggered rate control. The more
aggressive the setting, the more variation motion will have on the rate control. It
is strongly suggested to disable VBR aggressiveness for low bit rate scenarios
(below 1Mbps) as this parameter may negatively affect perceived video quality.
•
Point to Point
–
This section allows you to configure point to point video connections
(up to three) for creating persistent video streams from the encoder to a network
endpoint. This feature is particularly useful when combined with a hardware decoder .
.
•
PTZ
–
Do Not modify settings in this section.
o
Enabled
–
Must be enabled for PTZ operation.
–
o
Camera PTZ Id
–
Factory set. Do Not Modify [001].
o
Control Protocol
–
Factory set. Do Not Modify [Pelco D].
o
Serial Port
–
Factory set. Do Not Modify
o
Preset Tour
–
This sub-section allows you to configure up to 8 preset tours.
These tours are managed by the encoder module. See section 4.3 for more
details on this feature.
o
Custom Commands
–
Only available with certain PTZ protocols. Allows you to
set custom, non-standard, commands for transmission to a PTZ controller.
Changes to these settings can cause PTZ functions to fail.
To Next Page
Loading...
