SimonsVoss WaveNet - Page 198

Device Signalling Meaning reaction
WN.LN.R
2X short (red LED) Power-on reset.
1x (signal LED)
Transmit/receive
power between Lock-
Node and WN.XN.XR
poor (check by press-
ing a button on the
LockNode baseboard).
Improve the signal
quality (see
Improving
signal quality [}143] ).
2x (signal LED)
Transmit/receive
power between Lock-
Node and WN.XN.XR
sufficient (test by
pressing a button on
the LockNode base-
board).
3x (signal LED)
Transmit/receive
power between Lock-
Node and WN.XN.XR
optimal (check by
pressing a button on
the LockNode base-
board).
1x short (red LED)
Battery full (check
after power-on-reset).
1x long (red LED)
Battery low (check
after power-on reset).
1. Replace the
batteries (see
Battery change for
external
LockNodes
[}190] ).
1X long, four seconds
(red LED)
Battery very weak
(check after power-on
reset).
1. Replace the
batteries (see
Battery change for
external
LockNodes
[}190] ).
Permanent light (red
LED)
Software or hardware
defect.
1. Perform a power-
on reset (see
RouterNodes
[}150] ).
2. Replace the device
(see
Reprogram or
replace the device
[}154] ).
WaveNet (Manual)
7. Signalling the operating status
198 / 210