Simphoenix DL100 Series - Safety precautions

DL100 Series Universal Low-Power Inverter
Ⅱ Precautions
Weight and dimension
Model
Net weight
(KG)
Gross weight
(KG)
Outer box
dimension(mm)
DL100-2S0004
0.75
0.95
225×145×185
DL100-2S0007/DL100-2S0015
0.75
0.95
225
×
145
×
185
DL100-4T0007/DL100-4T0015
0.75
0.95
225
×
145
×
185
DL100-2S0022
1.2
1.5
250×165×200
DL100-4T0022/DL100-4T0040
1.2
1.5
250×165×200
DL100-4T0055/DL100-4T0075
1.9
2.3
285
×
185
×
210
We have strict quality assurance system for the products in terms of
manufacturing, packing and transportation. In case of any careless omission,
please contact us or local agent immediately. We will address the problem at
first time.
2．Safety precautions
In this manual, the wordings of “Danger” and “Caution” are defined as below.
2.1 Installation
1. The inverter shall not be installed on combustibles.
2. The frequency inverter shall not be installed at places with direct sunlight.
3. The frequency inverter of this series shall not be installed in the environment
of explosive gases, for fear of the danger of explosion.
4. No foreign matter is allowed to be dropped into the frequency inverter, for
fear of causing fires or injury.
5. During installation, the frequency inverter shall be installed at the place able
to bear its weight; otherwise, it may fall down or damage properties.
Danger: Serious damage to the equipment or personal injuries may
be caused if operating without following requirements.
Caution: Moderate injuries or minor injuries of personnel and material
loss may be caused if operating without following requirements.
The inverter shall not be dismantled or modified without authorization.