Simplicity 1693074 Service And Repair Manual

11 - 19
11 Transmission Teardown
Hydro-Gear 0500 / 0650
11.Install the washers and a new lip seal onto the
splined end of the motor shaft. Install one washer on
each side of the retaining ring.
12.Install the motor shaft into the center section.
Figure 27. Install Motor Shaft
Seal
Washers
Retaining Ring
Figure 28. Install Bypass Plate
13. Install the bypass plate (small end first) into the center
section.
Bypass
Plate
Figure 29. Install Motor Block Kit
14.Lubricate the running faces and install the motor
block kit onto the motor shaft.
Figure 30. Position Center Section Assembly
15.Position the washers and seal and install the center
section assembly onto the aligning pins and pump
input shaft.
NOTE: Be sure the center section is completely seat-
ed by hand. Do not pull the section down with the
capscrews. If the center section cannot be be
pushed down by hand, remove the center section
and check the alignment of the bypass actuator; oth-
erwise damage to the bypass plate will occur.

Simplicity 1693074 Specifications

General

Brand	Simplicity
Model	1693074
Category	Lawn Mower
Language	English