| 13
Installation | V5035 Operator and Installation Manual
Installation procedures
Please familiarize the manual content before begin installation. Use
the following recommended steps for installation.
1.
Mount the transponder unit to a desired location
2. Mount junction box
3. Install VHF antenna
4. Install GPS antenna
5. Connect all external sensors and data interfaces to the junction box
6. Connect all required cables to the main transponder unit
7. Power on the main transponder unit
8. Complete configuration settings
9. Perform system functional test
RF cable requirements
The following RF cables are recommended to install the V5035 - .
• VHF Antenna Cable
Type: 5D-FB or equivalent
Connector: SO-239 (Male)
• GPS Antenna Cable
Type: RG58A/U or equivalent
Connector: TNC (Male)
Cable and connector are supplied as part of the GPS antenna.
To Next Page
Loading...
Need help?
General
