4 |
Preface | V5035 Operator and Installation Manual
MAKE SURE THE POWER SOURCE AND THE POWER INPUT ARE
MATCH
Incorrect power sources will damage the equipment and may even
result in fire.
Please ensure the correct power input on the adaptor before instal-
lation.
AVOID DIRECT CONTACT WITH RAIN OR SPLASHING WATER
Electrical shock or fire could be resulted if water leaks into the
equipment.
NOTE/INFORMATION
¼ Note: Important notices and information will be noted in this Instal-
lation and Operation Manual
IV. Product Category
This product is categorized as “protected” in accordance with the
requirements as defined in IEC 60945.
V. Compass Safe Distance
Safe distance to the transponder (and junction box) unit is:
• Standard-magnetic-compass: 0.50 m
• Steering-magnetic-compass: 0.40 m
VI. Hardware / Software Version
• Hardware version: A -010
• Software version: 1.0.6.39
The model name/number, hardware information, and firmware
(software) version of the transponder can be identified through
MKD at MENU/DIAGNOSTICS/VERSION. The software maintenance/
upgrade of the transponder can be carried out on board via USB
interface. The onboard documentation as described in Appendix C
can be used to assist reflecting software maintenance records.
VII. Type Approval
The SIMRAD V5035 AIS transponder complies with applicable
international standards and is type approved in accordance with the
European Marine Equipment Directive.
To Next Page
Loading...
Need help?
General
