User Manual
EM100 Mini Inv
7. Do not di
Before Power-o
1.
Inverter s
electrical
2.
Wiring o
ust be performed by authoriz
eaker should be installed bet
hat the power supply is off
iring. Risk of electrical haz
g terminal must be grounded
ad is not recommended. Ris
nnect input power supply c
ay attention to the termina
at the wiring meets EMC re
in recommended sizes. Risk
nnect braking resistor to DC
rminals with screw drivers o
nnect phase-shifting capacit
onnect the solenoid switch
therwise, it will trigger over
sconnect internal wires of in
t the input voltage is identic
input terminals R, S, and T a
nd its peripheral circuits, and
form voltage withstanding te
all peripherals should abide
d and qualified personnel. R
een inverter and the mains.
before wiring, and ground
Risk of electrical hazard an
of unexpected danger.
able to output terminals U,
symbols, connect them cor
uirements and local safety st
of accident.
bus terminal & . Risk o
f specified torque. Risk of fir
r and LC/RC noise filter to o
and electromagnetic conta
erter. Risk of inverter damag
l to the rated voltage of prod
all wires should be in good c
st on inverter, it has been do
e front cover is assembled.
y the guide of this manual.