User Manual
EM100 Mini Inv
Trips
Bit setting value
After detecting t
status.
Bit setting value
After detecting t
protection.
F07.17 is bit ope
corresponding to
1. Never
inverter d
2. Refer to binary
3. OLP detection
and OL fault retry are per
ding bit of SOU=0 and the
0 0 0
0: Enabled
1: Disabled
SLU is LSB, arrang
e fault corresponding to the
e fault corresponding to the
ation, only set correspondin
or instance: Only set the 2
nd
.17=00000010. Set the 3
rd
EHt=1 to disable OLP and E
amage if there is no protectio
system parameter setting des
s enabled when the absolute
itted, other fault retries are p
th
corresponding bit of OL=0
it, inverter stops output and t
it, inverter remains previous
bit to protection= 0/1.As sh
it corresponding to ILP=1 to
t corresponding to OLP=1 a
ction unless special require
alue of output frequency>5.
efault Type
0000
0000
〇
hen enters fault
status without
0.00
5.00
10.00
15.00
20.00
25.00
30.00
00
〇