Singer 6021 - Winding a bobbin

18
Winding a bobbin
Winding a bobbin is quick and easy when you lollow the directions below. Always wind
the bobbin belore threading the machine and needle.
• Push in indent (1) on hand wheel discoThis will stop the needle Irom moving.
• Place spool 01thread on spool
pino
• SIide spool: cap (2) lirmly over rim 01spool to prevent thread tangling.
• Lead thread Irom spool and snap into thread guide post (3).
• Wind thread
clockwise around Iront 01bobb in winder tension disc (4).
• Pass thread end, Irom inside, through small hole in rim 01bobbin.
• Place bobbin on spindle and push it to the right.
• Holding thread end, step on speed controller to run machine until desired amount
01 thread
ls wound. (Winding stops automatically
once bobbin is lul!.)
• Cut thread ; push bobbin to the left and remove it Irom spindle.
• Trim thread end Irom top 01bobbin.
• Return hand wheel
disc to sewing position by pressing on side opposite indent.