Sirona CEREC MC - Entering Bar Codes

63 98 650 D 3439
44 D 3439.201.07.10.23 10.2017
6Operation Dentsply Sirona
6.5Entering the bar code Operating Instructions (valid for USA) Sirona Dental CAD/CAM System
6.5
Entering the bar code
Barcode Reader active
If you have activated the option "Barcode Reader" in the system
configuration dialog (e.g. for CEREC Zirconia), you must read-in both bar
codes with the bar code reader. To do this, hold the bar code reader tilted
to a slight angle and move it over both of the bar codes on the block
continuously and evenly.
If the reading process fails, you can read-in the bar code once again by
pressing
"Retry" (button 1 on the unit display). Alternatively, you also can
enter the substitute code (8-digit character string, e.g. *1234XYZ) on the
PC manually.
No bar code reader available
➢ Enter the substitute code (8-digit character string, e.g. *1234XYZ) on
the PC manually.