Sirona CEREC MC - Changing a Defective Instrument; Care, Cleaning Agents, and Disinfectants; Cleaning Surfaces; Disinfecting Surfaces

63 98 650 D 3439
56 D 3439.201.07.10.23 10.2017
7Service Dentsply Sirona
7.5Care, cleaning agents, and disinfectants Operating Instructions (valid for USA) Sirona Dental CAD/CAM System
Changing a defective instrument
If an instrument breaks during the machining phase, the corresponding
motor travels to the change position. A dialog box which marks the side
with the broken instrument with a red cross then opens.
✔ The instrument is broken.
1. Change the defective instrument as described above.
2. Select the instrument which you have inserted.
3. Press the
"Start" button.
7.5
Care, cleaning agents, and disinfectants
A continuously updated list of approved media can be downloaded from
the internet via the online portal for technical documents. You can reach
this portal at the address:
www.dentsplysirona.com/manuals
. Click on the menu item
"General documents" and then open the "Care,
cleaning and disinfection agents"
document
If you do not have internet access, please contact your dental depot to
order the list (REF 59 70 905).
7.6
Cleaning surfaces
7.6.1 Disinfecting
Wipe surfaces down with a surface disinfectant (wiping disinfectant).
Observe the manufacturer’s instructions regarding restrictions for use.
7.6.2 Protection against medicaments
Due to their high concentrations and the substances they contain, many
medicaments can dissolve, etch, bleach or discolor surfaces.
7.6.3 Cleaning
Remove dirt, grime and disinfectant residue regularly using mild,
commercially available cleaning agents.
NOTICE
Approved care, cleaning, and disinfecting agents
Use only care, cleaning, and disinfecting agents approved by Dentsply
Sirona!
NOTICE
Do not allow liquids to run into the ventilation slots!
NOTICE
Damage to the surface
Clean the surface immediately with a moist cloth and a cleaning agent.