Use and Operation
6-19
6.7 Use of exposure remote control
The remote control is used by the operator to achieve remote exposure control of the
device. The exposure modes have 2 keys of mode available.
The remote control has 2 keys. See Fig. 6-11. Press the "A" key, the remote control
indicator turns on and the X-ray machine makes a "Di" sound. Press the "B" key within 3
seconds, the remote control indicator turns on and the X-ray machine makes a "Di" sound.
See Fig. 6-12. Now for exposure level 1 indicator on the panel turns on.
When the device starts to emit X-rays,
for exposure level 1 indicator goes off.
The
indicator turns on and the X-ray machine makes a "Di" sound. When the
indicator goes off, the exposure complete indicator turns on
and then off. One exposure is completed. Release the remote control key at any current
step to end the current operation. After completing the exposure, press the remote control
"A" key to re-enter the 3s timing.
local laws and regulations or national standards.
g)
The discarded battery shall be safely disposed of, otherwise
there might be a danger of explosion or fire.
h)
Do not discard or disassemble the used battery, otherwise it
may result in unnecessary danger, such as an explosion or fire.
i) Do not charge the battery near a fire source or under strong
sunlight; do not use or place the battery under strong sunlight
(or in a car heated by sunlight) ; do not immerse the battery in
water or make it wet, otherwise it may cause the battery to heat
up, malfunction, fire or explode.
To Next Page
Loading...