A8 mini User Manual v1.5
23
2023 SIYI Technology Co., Ltd, All Rights Reserved
Mark
Above software can be downloaded from relevant product page on SIYI official website.
Steps
1. Power MK15 air unit and bind it with MK15 remote controller.
2. Use SIYI Gimbal to SIYI Link Cable to connect MK15 air unit’s Ethernet port with
gimbal camera’s Ethernet port.
3. Wire the 3 in 1 Control Cable with the MK15 / HM30 Air Unit S.Bus Y Cable.
4. Then use the combined cable to connect MK15 air unit’s RC port and gimbal
quick release board’s control signal port.
5. Install and run SIYI PC Assistant on Windows computer.
6. Use the USB-C to USB-A cable to connect the gimbal to the computer, then run
SIYI PC Assistant and go to “Gimbal Config” page.
To Next Page
Loading...
