MK32E User Manual V1.1
56
2023 SIYI Technology, All Rights Reserved
Steps
1. Before calibrating the dials, please make sure that both dials are naturally
standstill, not displaced by any force. And both knobs are at their middle
positions.
2. In “Dial Calibration” page, touch “Start”, the page shows as below.
3. According to the tips, if dials’ coordinates are not “(0, 0)” when both dials are
standstill, it means that dial middle points are displaced. Please touch “next”
and do not touch the dials.
To Next Page
Loading...
