MK32E User Manual V1.1
50
2023 SIYI Technology, All Rights Reserved
5. After configuration, the channel would output the value if the air unit lost
communication with the ground unit during flight.
Mark
If your flight controller communicates with the air unit through S.Bus protocol, then it is
unnecessary to configure your system with Failsafe function (unless it is specially required
by flight controller to activate Failsafe function and switch to RTH, by holding a specific
value in a channel). You just configure your GCS with protection measures, because there
are Out-of-Control marks in S.Bus protocol which tells the flight controller what situations
belong to Out-of-Control.
3.6 Buttons / Dials
MK32E ground unit supports changing the way buttons and dials work by software.
To Next Page
Loading...
