VD32 Remote Controller User Manual v1.2
- 89 -
2020 SIYI Technology Copyright
16 of the transmitter.
Steps
1. Power on the transmitter and the sky station, make sure that they are linked with
each other;
2. The PWM port 1 of the transmitter is mapped to the PWM port 1 of the sky
station, the PWM port 2 of the transmitter is mapped to the PWM port 2 of the
sky station…and so on;
3. In the “PWM Settings” menu, tap on a PWM port and select a channel through
the virtual turntable in the screen according to your requirement;
4. Tap on “SET” to finish.
To Next Page
Loading...
