Ski-Doo REV G4 Trail/Crossover E-TEC Series User Manual

TUNE YOUR RIDE
147
Rear Shock Lower Pivot Position
Upper Softer absorption
Lower
(From factory)
Reference absorption
To change the shock lower pivot position, proceed as follows:
1. Lift rear of the vehicle and support it off the ground.
2. Remove stopper strap screw to release tension.
3. Remove the shock lower screw and nut.
520002316-006
Note: It may be necessary to lower the vehicle and slightly
compress the suspension to remove the load.
4. Align shock with the upper hole.
5. Install the screw with a new nut and tighten to specifica-
tion.

Ski-Doo REV G4 Trail/Crossover E-TEC Series Specifications

General

Brand	Ski-Doo
Model	REV G4 Trail/Crossover E-TEC Series
Category	Snowmobiles
Language	English