Ski-Doo Skandic SWT User Manual

MONITORING SYSTEM
NOTE: Some of the listed pilot lamps do not apply to all models.
PILOT
LAMP(S)
ON
BEEPER DESCRIPTION
Engine is overheating, reduce snowmobile speed and run
in loose snow or stop engine immediately and let engine
cool down. Check coolant level, refer to
MAINTENANCE .If
coolant level is correct and overheating persists, contact an
authorized Ski-Doo dealer. Do not run the engine if condition
persists.
4 short
beeps every
30 seconds
Reduce speed or stop engine. Let engine cool down and
restart. If overheating persists, contact an authorized
Ski-Doo dealer. Do not run the engine if condition persists.
Critical overheat. Stop engine immediately and let engine
cool down. Check coolant level, refer to
MAINTENANCE .If
coolant level is correct and overheating persists, contact an
authorized Ski-Doo dealer. Do not run the engine if condition
persists.
Short beeps
repeating
rapidly
Critical overheat. Stop engine immediately and let engine
cool down. If overheating persists, contact an authorized
Ski-Doo dealer. Do not run the engine if condition persists.
Do not run the engine if condition persists.
4 short
beeps every
5 minutes
Indicate a low or high battery voltage condition. See an
authorized Ski-Doo dealer as soon as possible.
4 short
beeps
Engine fault, see an authorized Ski-Doo dealer as soon as
possible.
—
4 short
beeps every
5 minutes
Engine detonation (RPM is limited when this condition
occurs).
– Ensure recommended fuel is used.
– Check fuel quality, replace if necessary.
– If fault still occurs, contact an authorized Ski-Doo dealer.
—
4 short
beeps every
5 minutes
Engine RPM limited for protection when certain faults occur.
—
Short beeps
repeating
rapidly
Shutdown procedure in force due to engine overheating or
fuel pump problem, remove tether cord cap from engine
cut-off switch and contact an authorized Ski-Doo dealer.
______________
105

Ski-Doo Skandic SWT Specifications

General

Brand	Ski-Doo
Model	Skandic SWT
Category	Offroad Vehicle
Language	English