OPERATING INSTRUCTIONS
mmo2008-005-007
3. Attach the other end of emergency
rope to the starter clip supplied in
the tool kit.
mmo2008-005-009
4. Hook up clip on drive pulley.
mmo2008-005-012_a
1. Clip installation locati
on
5. Wind the rope tightly aro
und drive
pulley. When pulled, pulley must
rotate counterclockwise.
mmo2008-005-014_a
6. Pull the rope using a sharp, crisp pull
so the rope comes free of the drive
pulley.
WARNING
When starting the snowmobile
in an emergency situation, using
drive pulley, do not reinstall the
drive belt guard and return slowly
to have snowmobile repaired.
Vehicle Warm-Up
Before every ride, vehicle has to be
warmed up as follows:
1. Start engine as explained in
ENGINE
STARTING PROCEDURE
above.
2. Allow engine to warm up one or two
minutes at idle speed.
NOTE: It is not recommended to let
engine running at idle speed for more
than 10 minutes.
3. Disengage parking brake.
4. Apply throttle until drive pulley en-
gages. Drive at low speed the first
two or three minutes.
50
______________
To Next Page
Loading...
Need help?
General
