EasyManuals Logo

Ski-Doo Skandic SWT User Manual

Ski-Doo Skandic SWT
131 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #34 background imageLoading...
Page #34 background image
CONTROLS, INSTRUMENTS AND EQUIPMENT
WARNING
Make sure parking brake is fully
disengaged before operating the
snowmobile. When you ride the
vehicle, brake pads that are caused
to drag by a continuous pressure
on the lever may cause damage to
the brake system and cause loss of
braking capacity and/or fire.
To Engage Parking Brake
Apply and hold brake, then lock brake
lever using the parking brake lever as
shown.
mmo2009-005-006_a
TYPICAL ENGAGE MECHANISM
Step 1: Apply and hold regular brake
Step 2: Lock brake lever using parking brake
lever
To Release Parking Brake
Squeeze brake lever. Parking brake
lever will automatically return to its
original position. Always release park-
ing brake before riding.
5) Engine Cut-Off Switch
The engine cut-off switch is located to
on the LH side of console.
The tether cord cap must be securely
snapped to the engine cut-off sw
itch
to allow vehicle operation.
WARNING
Always attach the tether cord eye-
let to clothing before starting the
engine.
Pulling the tether cord cap from the
engine cut-off switch shuts the engine
off.
D.E.S.S. (Digitally Encoded Security
System)
600 ACE and 600 HO E-TEC Models
After engine starting, 2 short beeps
should be heard if a programmed
D.E.S.S. key (tether cord cap) is cor-
rectly snapped on engine cut-off
switch. If another beep code is heard,
refer to
MONITORING SYSTEM
for
D.E.S.S. malfunction codes informa-
tion.
The tether cord cap has an integrated
D.E.S.S. key to provide you and your
snowmobile with the equivalent secu-
rity of a conventional lock key.
The D.E.S.S. key contains an electronic
chip which features a unique perma-
nently memorized digital code.
Your authorized Ski-Doo dealer has pro-
gramed the D.E.S.S. of your snowmo-
bile to recognize the D.E.S.S. key in the
tether cord cap to allow vehicle opera-
tion.
If another tether cord is used without
programming the D.E.S.S., the engine
will start but will not reach drive pulley
engagement speed to move vehicle.
Make sure the tethercord cap is free of
dirt or snow.
32
______________

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ski-Doo Skandic SWT and is the answer not in the manual?

Ski-Doo Skandic SWT Specifications

General IconGeneral
BrandSki-Doo
ModelSkandic SWT
CategoryOffroad Vehicle
LanguageEnglish

Related product manuals