CONTROLS, INSTRUMENTS AND EQUIPMENT
Start Button
Press tostartengine. Referto
ENGINE
STARTING PROCEDURE
in the
OPER-
ATING INSTRUCTIONS
subsection.
Headlights Dimmer Switch
Press to select HI or LOW beam.
Lights are automatically ON when the
engine is running.
Heated Grips Switch
NOTE: The heated grips are enabled
above 2000 engine RPM.
Select the switch position according to
the desired heating intensity to keep
your hands at a comfortable tempera-
ture.
mmo2007-003-003_b
TYPICAL
1. Heated grip switch
2. Hot
3. Warm
4. Off
Heated Throttle Lever Switch
NOTE: The heated throttle lever is en-
abled above 2000 engine RPM.
Select the switch position according to
the desired heating intensity to keep
your thumb at a comfortable tempera-
ture.
mmo2007-003-003_c
TYPICAL
1. Heated throttle lever switch
2. Hot
3. Warm
4. Off
8) Gearshift Lever
Use this lever to select gears. The
gearbox has two forward gears, a re-
verse gear and a neutral.
Refer to
GEARBOX OPERATION
in
OPERATING INSTRUCTIONS
for de-
tails.
NOTE: It is necessary to push shift
lever knob down to move it from neu-
tral to reverse gear.
9) Adjustable Mirrors
Each mirror can be adjusted to suit
driver's preference by gently rotating
the mirror glass.
WARNING
Adjust with vehicle at rest in a safe
place.
10) Tool Kit
A tool kit containing tools for basic
maintenance is supplied with the vehi-
cle.
The tool kit support is located in engine
compartment on pulley guard.
NOTICE
Make sure tool kit is se-
cured properly to avoid contact with
drive belt or drive pulley.
34
______________
To Next Page
Loading...
