SJ85 AJ 213217AAA
13
Serial Number Nameplate Section 1 – About This Mobile Elevating Work Platform (MEWP)
1.3 Serial Number Nameplate
The serial number nameplate (refer to
Section 8), located at the rear of the MEWP, lists the
following:
▪
Model number
▪
Type
▪
Group
▪
Serial number
▪
High capacity zone and low capacity zone
▪
Capacity and maximum number of persons
▪
Maximum work platform height
▪
Maximum wind speed
▪
Maximum manual force
▪
Machine weight
▪
Voltage
▪
Maximum incline
▪
System pressure
▪
Lift pressure
▪
Model year
▪
Year of manufacture
1.4 Responsibility for
Maintenance
1.4-1 Operator’s responsibility for
maintenance
WARNING
Maintenance must be performed by trained and
qualied/competent personnel who are familiar
with mechanical procedures.
Death or serious injury could result from the use of
a MEWP that is not properly maintained or kept in
good working condition.
The operator must be sure that the MEWP has been
properly maintained and inspected before using it.
The operator must perform all the daily inspections
and function tests found in Section 4.4, even if
the operator is not directly responsible for the
maintenance of this MEWP.
1.4-2 Maintenance and inspection
schedule
Refer to service manual for frequent/periodic (every 3
months or 150 hours) and annual inspection details.
The actual operating environment of the MEWP may
affect the maintenance schedule.
WARNING
Use original or manufacturer-approved parts and
components for the MEWP.
NOTE
Refer to Skyjack’s website www.skyjack.com
for the latest service bulletins prior to performing
frequent/periodic or annual inspections.
1.4-3 Owner’s inspections
It is the responsibility of the owner to arrange daily,
quarterly (or 150 hours) and annual inspections of the
MEWP. Refer to the service manual for recommended
maintenance and inspection areas and intervals. A
record of annual inspection is kept on a label located
close to the base control console on the cowling (refer
to Section 7.3).
To Next Page
Loading...
Need help?
General
