EasyManuals Logo

Skyjack SJ85 AJ User Manual

Skyjack SJ85 AJ
112 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
SJ85 AJ 213217AAA
19
Jobsite Inspection Section 2 – Operator Safety
WARNING
Entering and exiting the MEWP should only be
done using the three points of contact.
Use only equipped access openings.
Enter and exit only when the MEWP is in the
fully retracted position.
Use three points of contact to enter and exit the
platform. Enter and exit the platform from the
ground only. Face the MEWP when entering or
exiting the platform.
Three points of contact means that two hands
and one foot or one hand and two feet are in
contact with the MEWP or the ground at all times
during entering and exiting.
WARNING
An operator should not use any MEWP that:
does not appear to be working properly.
has been damaged or appears to have worn
or missing parts.
has alterations or modications not approved
by the manufacturer.
has safety devices which have been altered or
disabled.
has been tagged or locked out for non-use or
repair.
Failure to avoid these hazards could result in death
or serious injury.
2.4 Jobsite Inspection
Ensure operating environment (i.e. operating
temperature, Electromagnetic Compatibility (EMC),
and hazardous location rating) is suitable to MEWP
specications (refer to Section 7.5).
Be sure to follow all local, provincial/territorial/state
and national regulations related to operating the
MEWP. Do not use MEWP in hazardous locations.
Perform a thorough jobsite inspection prior to
operating the MEWP to identify potential hazards in
your work area.
Be aware of moving equipment in the area. Take
appropriate actions to avoid collision.
It is the responsibility of the operator to perform a job
site inspection and avoid the following hazardous
situations:
holes or drop-offs
slopes
ditches or soft lls
oor obstructions, bumps or debris
overhead obstructions
electrical cords, hoses and high voltage
conductors
hazardous locations
inadequate surface support to withstand all load
forces imposed by the MEWP (refer to
Section 7.8)
wind and weather conditions
the presence of unauthorized personnel
the presence of other mobile equipment
trafc hazards
other possible unsafe conditions

Table of Contents

Other manuals for Skyjack SJ85 AJ

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Skyjack SJ85 AJ and is the answer not in the manual?

Skyjack SJ85 AJ Specifications

General IconGeneral
BrandSkyjack
ModelSJ85 AJ
CategoryBoom Lifts
LanguageEnglish

Related product manuals