Skyjack SJ85 AJ - Welder (if Equipped); Cold Weather Start (if Equipped); Arctic Weather Package (if Equipped)

SJ85 AJ 213217AAA
35
Optional Equipment and Attachments Section 3 – Familiarization
3.5-4 Welder (if equipped)
The welder is installed on the platform. Refer to the
welder’s operating manual for proper operation and
maintenance.
Figure 20 Welder
7
1
Welder - This equipment is plugged into its
dedicated AC outlet on the platform.
7
2
Welder AC outlet - This AC outlet is dedicated
for the welder.
NOTE
In sub-zero temperatures, the hydraulic oil should
be warmed, prior to operating the welder.
WARNING
Only qualied/competent persons should install,
operate, maintain and repair the welder.
CAUTION
Breathing welding fumes and gases can be
hazardous to your health.
3.5-5 Cold weather start (if equipped)
The battery warmer/hydraulic oil heater cord is
located in the engine compartment near the engine.
Figure 21 Battery warmer/Hydraulic oil heater cord
7
1
Battery warmer/Hydraulic oil heater cord -
This cord is plugged into the AC outlet at least 4
hours before starting engine when temperature
gets below -10°C (+14°F).
3.5-6 Arctic weather package (if
equipped)
The heater plug is located in the engine compartment
near the engine.
Figure 22 Heater plug
7
1
Battery/Hydraulic oil/Engine oil heater plug -
This cord is plugged into the AC outlet at least 4
hours before starting engine when temperature
gets below -18°C (0°F).
1
2
1
1
FAMILIARIZATION