SJ85 AJ 213217AAA
45
Visual & Daily Maintenance Inspections Section 4 – Pre-operation
6
Wheel/Tire assembly
▪
The MEWP is equipped with foam-lled tires.
Tire and/or wheel failure could result in a
MEWP tip over. Component damage may
also result if problems are not discovered and
repaired in a timely fashion.
1. Check all tire treads and sidewalls for cuts,
cracks, punctures and unusual wear.
2. Check each wheel for damage and cracked
welds.
3. Check each lug nut for proper torque to
ensure none are loose.
Refer to Section 7.6 for wheel/tire specications.
WARNING
Do not use tires other than those specied for this
machine. Do not mix different types of tires. Tires
other than those specied can adversely affect
stability. Failure to operate with matched, approved
tires in good condition may result in death or
serious injury. Replace tires with the exact,
Skyjack-approved types only.
7
Turret rotation gear
Inspect from underneath the MEWP.
▪
Ensure there are no loose or missing parts and
there is no visible damage.
8
Rotary manifold
Inspect from underneath the MEWP.
▪
Ensure all hoses are properly tightened and
there is no evidence of hydraulic leakage.
8
6
7
To Next Page
Loading...
