Note: Audio Description and Hearing Impaired options are only available if the TV
broadcast supports them.
Other Sengs
Digital Audio Output: You can select the digital audio output as Off / RAW / PCM.
Digital Audio Output Delay: For image and sound synchronization, you can change
the delay value of the audio.
Surround: Environment sound effect You can select as On or Off.
Audio Only: Only audio is heard without the screen being displayed. You can choose
between On or Off.
CHANNEL MENU
From this menu, you can adjust your TV's broadcast selection (DVB-T/T2, DVB-S/S2
or DVB-C), satellite dish, and channel settings.
Antenna Type: To set, choose one of the options Aerial / Cable / Satellite.
Here, it is referred to as "aerial," i.e. terrestrial broadcasting (DVB-T/T2), "cable," i.e.
cable TV broadcasting (DVB-C), and "satellite," i.e. satellite broadcasting (DVB-S/S2).
Scan: Here you can search for channels automatically or manually.
Analog scanning is used to scan cable or terrestrial TV ch
annels broadcast as analog
and digital scanning is used to scan cable or terrestrial TV channels broadcast as
digital.
Make sure that the antenna cable for the type of broadcast you will be using is
connected to the appropriate antenna input on your TV before you start scanning.
Satellite Antenna Tuning and Channel Scanning
To watch satellite broadcasts, first select the antenna type as "SATELLITE."
Select a Satellite Scan Mode: Select one of the options Network / Blind Scan.
Channel Type: Specify the channel search type by select
ing one of the options
Unencrypted / Encrypted / All.
Service Type: Select one of the options Radio / TV / All.
Add LNB: From the menu that opens, select the satellite you want to scan and press
OK/ENTER. Use the right arrow key to switch to the right-side window and set
DiseqC1.0. Return to the previous menu with the EXIT button.
31
To Next Page
Loading...