SMA Solar Technology AG 7 Commissioning
Installation Manual SI80H-60H-OffGrid-IA-en-11 87
16. Setting the generator interface:
• Select the 003.23 GnStrMod parameter and
press the button.
• If the generator does not have an electric starting device, set Manual and press the button.
• If the generator can be started and stopped using one contact, set Autostart and press the
button.
• If the generator is controlled using GenMan, set GenMan and press the button.
• Confirm the generator interface with Y.
17. Turn the button to the right.
☑ The Sunny Remote Control shows the last page
of Setup new system.
18. Press the button and confirm the question Done ? with Y.
19. Wait until the inverter LED of slave 1 flashes and the Sunny Remote Control displays
To identify Slave1 press Tss on the Slv.
20. Press the start-stop button on slave 1.
☑ A signal sounds and the QCG configures slave 1.
21. Wait until the inverter LED of slave 2 flashes and the Sunny Remote Control displays
To identify Slave2 press Tss on the Slv.
22. Press the start-stop button on slave 2.
☑ A signal sounds and the QCG configures slave 2.
23. Press the button on the Sunny Remote Control to terminate the QCG.
☑ The off-grid inverter switches to standard mode.
24. Configure the next cluster until all clusters have been configured.
To Next Page
Loading...
