SMA SUNNY TRIPOWER X 20-US - Mount the Product

5 Mounting
SMA Solar Technology AG
Operating manualSTPxx-US-50-BE-en-1132
☐ If multiple products are mounted in areas with high ambient temperatures, increase the
clearances between the products and ensure sufficient fresh-air supply.
Figure 6: Recommended clearances(Dimensions in mm (in))
5.2 Mount the product.
Additionally required mounting material (not included in the scope of delivery):
☐ For transport with a hoist: 2 eye bolts (M8)
☐ For mounting:
– 2 screws that are suitable for the support surface and the weight of the inverter
– 2 washers suitable for the screws
☐ To protect the product against theft: 1 padlock suitable for outdoor use. The padlock shackle
should have a 7.5 mm (0.375in) diameter.
CAUTION
Risk of injury due to weight of product
Injuries may result if the product is lifted incorrectly or dropped while being transported or
mounted.
• Transport and lift the product carefully. Take the weight of the product into account.
• Use the carrying handles or hoist when transporting the product. To attach the hoist system,
eye bolts must be screwed into the threads provided, which are located on the right and left
of the product's mounting lugs.
• Wear suitable personal protective equipment for all work on the product.
Procedure:
1. Align the mounting bracket horizontally and mark the position of the drill holes.
2. Set the mounting bracket aside and drill the marked holes.