SMA SUNNY TRIPOWER X 20-US - Resetting the Product to Default Setting; Deleting the Admin Account

8 Operation
SMA Solar Technology AG
Operating manualSTPxx-US-50-BE-en-1164
Procedure:
1. Select the menu Configuration.
2. Select the Device management menu item.
3. Select the button.
4. Select SMA Speedwire devices and confirm with [Next].
☑ All SMA Speedwire devices in the systems are searched for and displayed.
5. Enable SMA Speedwire encryption and select [Continue].
6. Assign a new system password and select [Save].
8.7 Resetting the product to default setting
Loss of data due to replacement or due to resetting to default settings
If the product is reset to the default settings or replaced, all data saved in the product and the
admin account will be deleted. The data saved in SunnyPortal can be transmitted to the
product after calling up the SunnyPortal system again.
Requirements:
☐ The user interface must be open and you must be logged in.
Procedure:
1. Select the product in the focus navigation.
2. Select the menu Configuration.
3. Select the menu item Device properties.
4. Select the button [If you want to reset the device to the default settings, click here].
5. Select [Reset].
8.8 Deleting the Admin Account
In case the password gets lost, the admin account can be reset and newly created. All system data
will be retained.
Requirements:
☐ The Device Key from the label on the back of the supplied manual must be present.
☐ The login page of the user interface must be open.
Procedure:
1. Select the [Delete admin account?] button.
2. Enter the Device Key from the label on the back of the supplied manual.
3. Select [Delete].
☑ The product is performing a restart. Then a new admin account can be created.
Also see: