SMA SUNNY TRIPOWER X 20-US - Manual Restart after Electric Arc

11 Troubleshooting
SMA Solar Technology AG
Operating manualSTPxx-US-50-BE-en-1190
2. Press the two locking tabs together to release the
fan drawer and carefully pull the enclosure with the
fan out downward.
2
1
1
3. Disconnect the fan connector in the unlocked state.
4. Clean the fan assembly with a soft brush or a vacuum cleaner.
5. Reinstall the serviced fan assembly in the inverter.
6. Recommission the inverter (see Section7.3, page55).
11.5 Manual restart after electric arc
You can use the following parameter to resume feed-in operation after an electric arc has been
detected.
Channel Name Settings
Operation.OpMod General operating mode Start
Also see:
• Arc-Fault Circuit Interrupter (AFCI)⇒page27
• Arc-Fault Circuit Interrupter (AFCI)⇒page65