Smanos X500 - Set Disarm Password; Setting Single Zone Delay Time

29
30
Set disarm password
Disarm password(4-6 digits):
1234
Disarm password(4-6 digits):
8888
Set disarm password successfully.
Left is the response message of the alarm
system shown when texting “13“ to the control
panel. Copy the message and adjust the
password as shown below.
In the App:
The default disarm password is 1234. To change the disarm password, follow the menu
below:
Setting single zone delay time
Single zone delay time
(0-300 sec.):
30
Single zone delay time (0-300 sec.):
15
Set single zone delay time successfully.
Left is the response message of the alarm
system shown when texting “14“ to the control
panel. Copy the message and adjust the delay
time for the single zone as shown below.
In the App:
The system will be delayed to alarm if single delay zone sensor is triggered. It is
recommended to set the entry door/window contact in single delay zone.
14
13
PIR-900 Wireless PIR Motion Detector
IMPORTANT: WHEN SINGLE DELAY ZONE IS SELECTED, THE SENSOR
WILL ALWAYS BE IN THE NORMAL ZONE. IT IS NOT POSSIBLE TO PLACE IT IN
THE HOME GROUP.
5
TIP: Always start the SIM card telephone number with the area code of your
country (eg. 0031 for the Netherlands). This will allow you to operate the alarm
system abroad.
8
17
18
19
20
24
X500 Alarm
X500 Alarm
smanos holding...