Smanos X500 - Set Duress Code; Set Timing

31
32
Duress code:
1111
Operate successfully.
Duress code:
2345
Set duress code
The default duress code is 1111. Duress code can be used when the user is threatened
to disarm the system. When using duress code to disarm the system, the control panel
will dial out silently. Change the duress code by following the menu:
Left is the response of the alarm system show when texting "15"
to the control panel. Copy the message and change the duress
code (four digits).
In the App:
15
Set timing
Below is the response message of the alarm system shown when texting “16“ to the
control panel. Copy the message and adjust the timing as shown below.
Timing:
1.00:00 0
2.00:00 0
3.00:00 0
4.00:00 0
5.00:00 0
6.00:00 0
Timing:
1.09:00 1
2.18:00 0
3.00:00 0
4.00:00 0
5.00:00 0
6.00:00 0
Operate successfully.
Leftistheresponseofthealarmsystemshowwhentexting“16“to
thecontrolpanel.Copythemessageandchangethesettings.
IMPORTANT: "0" = TURN OFF THE TIMING. "1" = ARM. "2"=DISARM.
Please synchronize panel time before set timing. See details on page 34.
16
PIR-900 Wireless PIR Motion Detector
IMPORTANT: WHEN SINGLE DELAY ZONE IS SELECTED, THE SENSOR
WILL ALWAYS BE IN THE NORMAL ZONE. IT IS NOT POSSIBLE TO PLACE IT IN
THE HOME GROUP.
5
TIP: Always start the SIM card telephone number with the area code of your
country (eg. 0031 for the Netherlands). This will allow you to operate the alarm
system abroad.
8
17
18
19
20
24
X500 Alarm
X500 Alarm
smanos holding...