Smanos X500 - Getting Started with Your Alarm System; SIM Card Installation; Control Panel Power-Up; Network Connection Indicator

8
7
1.
2.
3.
4.
Getting Started
Inserting SIM card
Before inser ting the SIM card, please perform the following steps:
Makesurethealarmsystemispoweredoff.
IMPORTANT:removethe(default)codepermanentlyfromtheSIMcard.
Turnoffthevoicemailfunctionifitisenabled.
InserttheSIMcardintotheSIMcardslotfromthealarmsystemasshowninthe
illustrationbelow.
IMPORTANT: In order to use and set up the alarm system, SMS texting
will be used. The use of SMS texting cost money. Consult your carrier for
the costs.
IMPORTANT: The Android and/or Apple App both make use of SMS texting.
SPK
GND
PUSH
GND
ZONE 1
24H ZONE
Wired connection (Siren 12V≤500mA)
Output for electronic lock
Wired sensor (Normal zone)
Wired sensor (24-H zone)
OFF O N
The settings of the alarm system can be changed by simply sending a SMS with a
mobile phone. You can request an entire menu for information on possible SMS
commands. The complete menu consists of three parts which can be requested by
sending one, two or three question marks as can be seen below.
Sending “ ? ”
Control panel replies:
Settings inquiry by SMS
Turning on the control panel
Connect the power adapter to the connector in the back of the control panel. Then
slide the power switch to “On“.
Network connection (indicator)
After switching on the system, the network icon will show on the LCD screen. This [ ]
indicates that the control panel is connected to a network.
IMPORTANT: If the network icon does not shown on the LCD screen, the control
panel has not connected to a network. Make sure the security code of the SIM
card is permanently deactivated.
‘0’ Disarm
‘1’ Arm
‘2’ Home mode
‘3’ Two-way talk
‘4’ Call-back voice memo
‘00’ Settings inquiry
‘??’ Store phone and SMS No.
?
PIR-900 Wireless PIR Motion Detector
IMPORTANT: WHEN SINGLE DELAY ZONE IS SELECTED, THE SENSOR
WILL ALWAYS BE IN THE NORMAL ZONE. IT IS NOT POSSIBLE TO PLACE IT IN
THE HOME GROUP.
5
TIP: Always start the SIM card telephone number with the area code of your
country (eg. 0031 for the Netherlands). This will allow you to operate the alarm
system abroad.
8
17
18
19
20
24
X500 Alarm
X500 Alarm
smanos holding...