11
12
Phone dial
Changing the language
English
Enter a phone number and press the button. The system dials out and you can
make the call via the built-in microphone and speaker of the alarm system. When you
press again the call is ended.
Send a SMS message with "0001" to the telephone number of the SIM card in the
control panel. The language of the alarm system will be changed into English. The
control panel will send a SMS message to confirm the language is set successfully.
Speed dial
When you press the button for 3 seconds, the system will dial the preset emergency
number immediately. The call ends when you press the button again. How to set the
speed dial number can be found at page 22.
Record and play back voice message
Naming RFID tags
Press the button for 2 seconds to record a
personal message of up to 10 seconds. If your
message is shorter than 10 seconds, press the
button to stop recording. The voice message
can be played back by pressing the for 2
seconds.
Besides the ability to disarm the system, the RFID tags can be given a name. If
someone disarm the alarm system, a message with the name will be sent to the pre-
stored RFID text number.
Administrator
Mom
IMPORTANT: The administrator can only receive a notification if the RFID tag
has been assigned a SMS number for RFID tags is stored. (Settings can be found
at page 21 and 25.
Nancy came home
Nancy
PIR-900 Wireless PIR Motion Detector
IMPORTANT: WHEN SINGLE DELAY ZONE IS SELECTED, THE SENSOR
WILL ALWAYS BE IN THE NORMAL ZONE. IT IS NOT POSSIBLE TO PLACE IT IN
THE HOME GROUP.
5
TIP: Always start the SIM card telephone number with the area code of your
country (eg. 0031 for the Netherlands). This will allow you to operate the alarm
system abroad.
8
17
18
19
20
24
X500 Alarm
X500 Alarm
smanos holding...
To Next Page
Loading...
