57
58
Caution and Warnings
Due to laws and regulations determined by the Euopean Parliament, some (wireless)
devices may be subject to restrictions on its use in certain European countries. In some
EU Member States, the use of equipment are prohibited. Contact your (local)
government for more information on these restrictions.
Always follow the instructions in the manual, especially when it concerns devices which
need to be assembled.
Warning: in most cases it is an electronic device. Incorrect or improper uses of the
device may result in (serious) injuries.
Repairing the unit must be done by smanos qualified personnel. The warranty expires
immediately if the unit is repaired and/or when the product is misused.
Note: smanos manuals are made with the utmost care. Due to new
technological developments, it may happen that a printed manual does not
contain the latest information.
Note: If you experience problems with the printed instructions, always visit our
website where the most recent manual is available for www.smanos.com
downloading.
Troubleshooting
Check if RFID SMS notification number and RFID tags
name were stored
Press the tamper switch on the bottom of control panel for
three times within 5 seconds, and all the connection between
the control panel and accessories will be cleared. Pay
attention not to trigger the tamper switch frequently when
installing the control panel
Whether the SIM card has enabled Caller ID Display function
Whether the cell phone number is set as alarm number
When the GSM network indicator blinks once per second
the network is being searched. When the indicator blinks
once every two seconds a network has been found.
When the PIR motion detector is triggered 2 times in 3
minutes it automatically goes into power saving mode.
When no movement is detected in the next 3
minutes it will set itself in the normal mode. During the 3
minutes the detector won’t be active and will not send a
signal to the control panel. As long as motion is detected
within the 3 minutes the power saving mode will be
extended.
Swiping RFID tags
without sending
SMS notification
The detector, remote
control and other
accessories do not
response any more
after the control
panel is moved
Get replied SMS
“Phone number is
unauthorized.”
GSM network
indicator blinks
Motion detector
doesn’t seem to
work properly
PIR-900 Wireless PIR Motion Detector
IMPORTANT: WHEN SINGLE DELAY ZONE IS SELECTED, THE SENSOR
WILL ALWAYS BE IN THE NORMAL ZONE. IT IS NOT POSSIBLE TO PLACE IT IN
THE HOME GROUP.
5
TIP: Always start the SIM card telephone number with the area code of your
country (eg. 0031 for the Netherlands). This will allow you to operate the alarm
system abroad.
8
17
18
19
20
24
X500 Alarm
X500 Alarm
smanos holding...
To Next Page
Loading...
