Appendix A
A.1
CERTIFICATIONS INFORMATION
European Directive Information
Authorized representative in European Community
Smar Gmbh-Rheingaustrasse 9-55545 Bad Kreuzanach
EMC Directive (2004/108/EC) – Electromagnetic Compatibility
The EMC test was performed according to IEC standard: IEC61326-1:2006, IEC61326-2-
3:2006, IEC61000-6-4:2006, IEC61000-6-2:2005. For use only in industrial environment.
ATEX Directive (94/9/EC) – Equipment and protective systems intended for use in
potentially explosive atmospheres.
This product was certified according European Standards at NEMKO and EXAM (former
DMT). The certified body for manufacturing quality assessment is EXAM (number 0158).
LVD Directive 2006/95/EC – Electrical Equipment designed for use within certain
voltage limits
According the LVD directive Annex II the equipment under ATEX “Electrical equipment for
use in an explosive atmosphere” directive are excluded from scope from this directive.
Other Certifications
IP68 Report:
Certifier Body: CEPEL
Tests for Ingress Protection IP68 – CEPEL DVLA – 7390/05C
This report not applies to hazardous locations Ex d protection and with Drawing 101B-
4740-00.
For guarantee the ingress of protection IP68 in the electrical connection input with NPT
thread must be applied a threadlocker like Loctite 262.
Documents for manuals:
Label Plate: 101A-8823
Hazardous Locations Certifications
North American Certifications
FM Approvals
Certificate N: FM 3W0A4.AX
Intrinsically Safe for use in Class I, Division 1, Groups A, B, C and D, Class II, Division 1, Groups
E, F and G, Class III, Division 1; in accordance with entity requirements and control drawing
102A-0005. Entity parameter: Vmax = 30 Vdc Imax = 110 mA Ci = 5 nF Li = 8 uH.
Non- incendive for Class I, Division 2, Groups A, B, C and D.
Explosion-proof for Class I, Division 1, Groups A, B, C, and D;
Dust-ignition proof for Class II and Class III, Division 1, Groups E, F, and G; hazardous
locations.
Ambient Temperature: (-20ºC < T
amb
<+60ºC).
Enclosure Type 4X/6 or Type4/6.
Canadian Standards Association (CSA)
Certificate N: CSA1110996
Class 2258 02 Explosion Proof for Class I, Division 1, Groups B, C and D; Class II, Division 1,
Groups E, F and G; Class III, Division 1; Class I, Division 2, Groups A, B, C and D; Class II,
Division 2, Groups E, F and G; Class III, conduit seal not required.
Class 2258 03 Intrinsically Safe and Non-Incendive Systems for Class I, Division 1, Groups A, B,
C and D; Class II, Division 1, Groups E, F and G; Class III, Division 1
To Next Page
Loading...
