SMART Board M600ix3 - Page 64

APPENDIX A
REMOTELY MANAGING THE SYSTEM THROUGH A NETWORK INTERFACE
56 smarttech.com/kb/170910
Submenu setting Description
IP Address Displays or allows you to set the projector’s IP address in values
between 0.0.0.0 and 255.255.255.255.
Subnet Mask Displays or allows you to set the projector’s subnet mask number in
values between 0.0.0.0 and 255.255.255.255.
Gateway Displays or allows you to set the projector’s default network
gateway in values between 0.0.0.0 and 255.255.255.255.
DNS Displays or allows you to set the projector’s IP address for your
network’s primary domain name server in values between 0.0.0.0
and 255.255.255.255.
Group Name Displays or allows you to set the projector’s workgroup name
(maximum 12 characters).
Projector Name Displays or allows you to set the projector’s name (maximum 12
characters).
Location Displays or allows you to set the projector’s location (maximum 16
characters).
Contact Displays or allows you to set the contact name, number or email
address for projector support (maximum 16 characters).
SNMP Turns the Simple Network Management Protocol (SNMP) agent on
or off.
Read-Only Community Sets a password that is required for each SNMP get request to
thedevice.
NOTE
The default for Read-Only Community is public.
Read/Write Community Sets a password that is required for each SNMP set request to the
device.
NOTE
The default for Read/Write Community is private.
TRAP Destination Address Displays or allows you to set the IP address of the network’s SNMP
TRAP manager in values between 0.0.0.0 and 255.255.255.255.
The TRAP destination address is the IP address of the computer
assigned to handle unsolicited data generated by SNMP TRAP
events generated by the projector, such as power state changes,
projector failure modes, a lamp needing to be replaced or other
issues.