SMART Board M600ix3 - Network Information; Command;Response Definitions; Field Definitions

APPENDIX B
REMOTELY MANAGING THE SYSTEM THROUGH AN RS-232 SERIAL INTERFACE
74 smarttech.com/kb/170910
Network information
Use these commands to set your network information.
Command/response definitions
Command Response Powered off
get netstatus netstatus=[current] yes
set network network=[current] yes
get network network=[current] yes
set dhcp [target] dhcp=[current] yes
get dhcp dhcp=[current] yes
set ipaddr [target] ipaddr=[current] yes
get ipaddr ipaddr=[current] yes
set subnetmask
[target]
subnetmask=[current] yes
get subnetmask subnetmask=[current] yes
set gateway [target] gateway=[current] yes
get gateway gateway=[current] yes
set primarydns [target] primarydns=[current] yes
get primarydns primarydns=[current] yes
get macaddr macaddr=[MAC
address]
yes
Field definitions
Field Possible values Description
current netstatus l connected
l disconnected
Current status of the network interface
current network l on
l off
Current status of the network module and the
VGA output
target network l on
l off
Enable/Disable network module and VGA
output