SMART Board M600ix3 - Simple Network Management Protocol (SNMP)

APPENDIX A
REMOTELY MANAGING THE SYSTEM THROUGH A NETWORK INTERFACE
59 smarttech.com/kb/170910
NOTES
l The first time you enable the password settings, the default password value is four numbers,
for example, 1234.
l The maximum allowable password length is four numbers or letters.
l If you forget the projector password, refer to Accessing the service menu on page48 to set
the projector setting to factory defaults.
Simple Network Management Protocol (SNMP)
The projector supports a list of SNMP commands as described in the management information
base (MIB) file. You can download this file by browsing to smarttech.com/software and clicking the
MIB file’s link in the Hardware section for the projector.
The SNMP agent in your projector supports SNMP version 1 or 2. Upload the MIB file to your SNMP
management system application, and then use it as described in your application’s user guide.