SMART Board M600ix3 - System Information; Command;Response Definitions

APPENDIX B
REMOTELY MANAGING THE SYSTEM THROUGH AN RS-232 SERIAL INTERFACE
75 smarttech.com/kb/170910
Field Possible values Description
current dhcp l = on
l = off
Enable/Disable for DHCP Networking
target dhcp l on
l off
Enable/Disable for DHCP Networking
current ipaddr
Range: 0.0.0.0 to
255.255.255.255
Current IP address (static or dhcp assigned)
target ipaddr
= Range: 0.0.0.0 to
255.255.255.255
Set to static IP Address
current subnetmask
Range: 0.0.0.0 to
255.255.255.255
Current subnet Mask
target subnetmask
= Range: 0.0.0.0 to
255.255.255.255
Target subnet Mask
current gateway
Range: 0.0.0.0 to
255.255.255.255
Current gateway
target gateway
= Range: 0.0.0.0 to
255.255.255.255
Target gateway
current primarydns
Range: 0.0.0.0 to
255.255.255.255
Current primary dns
target primarydns
= Range: 0.0.0.0 to
255.255.255.255
Target primary dns
MAC address
xx-xx-xx-xx-xx-xx
The device’s MAC address.
System information
Use these commands to set the system information.
Command/response definitions
Command Response Powered off
set autosignal [target] autosignal=[current] no
get autosignal autosignal=[current] no
set lampreminder
[target]
lampreminder=
[current]
no
get lampreminder lampreminder=
[current]
no