APPENDIX B
REMOTELY MANAGING THE SYSTEM THROUGH AN RS-232 SERIAL INTERFACE
76 smarttech.com/kb/170910
Command Response Powered off
set lampmode [target] lampmode=[current] no
get lampmode lampmode=[current] no
set ImageCare [target] ImageCare=[current] no
get ImageCare ImageCare=[current] no
set autopoweroff
[target]
autopoweroff=[current] no
get autopoweroff set
zoom [target]
autopoweroff=[current] no
set zoom [target] zoom=[current] no
get zoom zoom=[current] no
set projectorid [target] projectorid=[current] no
get projectorid projectorid=[current] no
set aspectratio [target] aspectratio=[current] no
get aspectratio aspectratio=[current] no
set projectionmode
[target]
projectionmode=
[current]
no
get projectionmode projectionmode=
[current]
no
set startupscreen
[target]
startupscreen=[current] no
get startupscreen startupscreen=[current] no
set restoredefaults restoredefaults=
[current]
yes
get lamphrs lamphrs=[current] yes
set lamphrs [target] lamphrs=0 yes
get syshrs syshrs=[current] yes
get resolution resolution=[current] no
get nativeaspectratio nativeaspect=[native] no
get fwverddp fwverddp=[current] yes
get fwvernet fwvernet=[current] yes
get fwvermpu fwvermpu=[current] yes
To Next Page
Loading...
