SMART Board M600ix3 - Field Definitions

APPENDIX B
REMOTELY MANAGING THE SYSTEM THROUGH AN RS-232 SERIAL INTERFACE
87 smarttech.com/kb/170910
Command Response Powered off
get vgacalibration vgacalibration =
[current]
no
get waveformid waveformid=[current] no
get lampvoltage lampvoltage =[current] no
get temperature temperature =[current] no
set temperaturereport
[target]
temperaturereport=
[current]
no
set
downloadlampdriver
[target]
downloadlampdriver=
[current]
no
clearfailurelog no
set burnin no
dwscaler#7537 no
Field definitions
Field
Possible Values
Description
target dbmsg
l
on
l
off
Turn on/off debug message.
current vgacalibration
l
??? To get the status of ADC calibration while
power on.
current waveformid
l
??? To get waveform ID while power on.
current lampvoltage
l
??? To get lamp voltage while power on.
current temperature
l
??? To get system temperature while power on.
target
temperaturereport
l
on
l
off
While set to on, the system temperature is sent
every five seconds (requires high-speed fan
mode to be on)
target
downloadlampdriver
l
done Auto program waveform while standby
clearfailurelog
l
done Clear all failure log for production burn in
preparation.
dwscaler#7537 Enter DDP download mode