SDRe Programming Software
Figure 24: Repeater Parameters tab
4.3.1.1. Repeater name:
This is an Alphanumeric Nickname assigned to the repeater to
get an easy access to this reference in the future, when you must
administrate a network.
4.3.1.2. Repeater ID:
This is a very important parameter in case you define a network
of repeaters into the system. This ID will help to identify each
repeater sharing the same IP address.
The ID must be unique into the entire system. Please be sure you are not defining the same ID for two
repeaters into the same network. Repeater ID is also used for Voting management.
Note: 10 – Unique ID advertence
To Next Page
Loading...